Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Repair in Commack: What to Know First
Olympia Chimney chimney repair in Commack runs $185 to $1,850 depending on what’s actually wrong, and we can usually have a sweep on your roof within three to five days. Most Olympia jobs we see are mortar repointing, flashing repair, and spalling brick replacement – the chimney structure itself needs attention long before the pipe inside does. We’re an independent Olympia Chimney service provider, so we tell you straight whether the repair is urgent or can wait, and the price we quote over the phone is the price on the invoice.
This page is for Commack homeowners who own an Olympia Chimney system and want someone who knows how that equipment behaves on Long Island. If you’re in Burr Farms, the Woods, or anywhere else in the 11725 zip code, call (631) 502-3612 for a free estimate. Wendell Pike answers his own phone more often than not.
How Olympia Chimney Products Fail – and How We Fix Them
Your flue doesn’t care how the fire looks. It cares how it breathes. Olympia Chimney builds solid equipment, but every line has its weak points. Here’s what we pull off roofs in Commack year after year:
- Olympia Stainless Steel Rigid Liner – seam separation at flex joints. The rigid sections hold up fine, but the flex connectors near the smoke shelf develop pinholes from sulfur and creosote acid after 8-12 years. We see it on Commack chimneys that burn a lot of pine or Bradford pear. Fix: we cut out the bad flex section and weld in a new connector, or reline the whole run if the corrosion spread.
- Olympia Rain Cap – bird and debris entry, plus wind-driven rain. The standard mesh screen is 3/4-inch, which keeps out raccoons but not starlings. Once you’ve got a nest in there, draft goes to zero fast and moisture gets trapped against the crown. Fix: pull the cap, clean the nest, and install a tighter 5/8-inch mesh or a screened multi-flue cap if you have more than one flue. On coastal Commack homes, the caps also need re-tacking where storm winds loosened the mount.
- Olympia Terra Cotta Flue Tiles (installed up through the late 1990s) – hairline cracking from freeze-thaw. Commack winters don’t get Minnesota cold, but the temperature swing between a 500-degree flue and a 20-degree night is more than enough to crack a clay tile. Once cracked, creosote seeps behind the tile and the chimney gets a tar smell in summer. Fix: HeatShield resurfacing where the damage is surface-level, or a full stainless reline with an Olympia-compatible liner if the cracks run deep.
- Olympia Periscope Caps and Custom Crowns – mortar cap decay around the perimeter. The prefab crowns sit well, but the mortar bed they sit on erodes and lets water run between crown and brick. The bricks spall, cap shifts, and you get rust stains down the face. Fix: remove the cap, grind out the old mortar, set it back on a proper crown formed with a slope and a drip edge, then waterproof the whole top.
- Olympia Masonry Chimney brick veneer over a steel liner – spalling where the brick meets the crown. This is one we see constantly in Burr Farms. The steel liner inside is fine, but the exterior brick absorbs rain, freezes, and pops off its face. Spalling brick repair is what we’re out there doing most springs. Fix: cut out the bad brick, match the color and texture, bed the new brick in a mortar with a higher alkali resistance, and parge the joint so water doesn’t sit there anymore.
Our Olympia Chimney Chimney Repair Process
You call, we show up with a price already agreed to, and we don’t invent problems the camera doesn’t show. Here’s how it goes for a typical Olympia Chimney repair in Commack:
- 1
The call. You reach a live person – possibly Wendell. You describe what you’re seeing: water stains on the ceiling, spalling brick, a cap that’s rattling. We give you an honest range and book a time, no trip charge inside the county.
- 2
The roof inspection. Wendell or one of his crew walks the roof, pops the cap if needed, and runs a camera down the flue. You get to watch the footage. No guesswork, no “trust us.”
- 3
The plain-English verdict. You see exactly what the camera saw. We tell you what’s urgent, what can wait, and what the options cost. If it doesn’t need doing, we’ll be the first one to tell you.
- 4
The repair. We decide together on OEM Olympia parts or a quality aftermarket equivalent – usually same quality, sometimes a better price, always warranty-safe. Then we do the work: repoint, reline, rebuild, reflash, waterproof.
- 5
The test. We fire the system if possible, check draft with a smoke test, and run the camera again so you see the finished job from inside the flue.
- 6
The guarantee. You get our 90-Day Done Right Promise in writing. If it’s not right, one call brings us back at no additional cost.
What Olympia Chimney Chimney Repair Costs in Commack
Here’s real money for real Olympia Chimney repair jobs, priced for Commack’s labor market in 2026:
| Repair Type | Typical Cost in Commack |
|---|---|
| Mortar repointing (small section) | $185 – $450 |
| Spalling brick replacement (2-4 bricks) | $275 – $600 |
| Chimney waterproofing (full exterior) | $400 – $750 |
| Flashing repair or replacement | $350 – $875 |
| Partial chimney rebuilding (top 2-3 feet) | $1,200 – $1,850 |
| Tuckpointing (full chimney face) | $45 – $75 per square foot |
What moves the price: how high the chimney is, how much scaffolding we need, whether brick matching is straightforward, and how much of the old work was done right the first time. We quote upfront, before a single tool comes off the truck, and that number doesn’t change. Call (631) 502-3612 for an exact price – estimates are free.
Why Commack Homeowners Call Top Hat Chimney for Olympia Chimney Work
Ask anyone on your street. We’ve been running crews through Suffolk County since 1999, and the bulk of it is repeat work and referrals from neighbors who watched the job get done. Wendell Pike puts his name and license number on every invoice, lives close enough to run into you at the hardware store on Saturday, and backs every Olympia Chimney repair with our 90-Day Done Right Promise in writing. If it’s not right, one call brings us back. No arguing, no disappearing act.
We work with trusted industry brands beyond Olympia, so if your chimney needs a repair that calls for DuraFlex, HeatShield, or Gelco material, we have it on the truck or know exactly where to get it. The sweep who shows up is background-checked, in uniform, and gives you a real arrival window that actually sticks. And yes – we answer the phone 24/7, and it’s a person, not a press-1 menu. First-degree creosote is a brush job. Third-degree is a glaze – catch it early.
FAQs
No, not when the repair is done correctly with compatible materials. An independent Olympia Chimney service provider like Top Hat Chimney can perform structural repairs – repointing, rebuilding, flashing – without touching the warranty on your liner or prefab components. Where replacement parts are called for, we use Olympia OEM or a quality aftermarket equivalent that meets the same spec, and we document every part we put in. If you have a warranty question, we’ll help you figure out what’s covered before we start. Call (631) 502-3612 and ask for Wendell.
Yes. Olympia has good distribution in the Northeast, and we can get most liners, caps, and crown components in under a week. That’s part of why we stock a fair amount of Olympia hardware on the truck. If a part is backordered, we’ll tell you that straight up and give you the option of a quality aftermarket substitute that often costs less and fits the same.
It depends on what the camera shows. If the liner is intact, the brick face has some spalling, and the crown is cracked but the structure is sound, repair is almost always the cheaper call – usually under $1,000. If the flue liner is degraded, the bricks have shifted, and the chimney leans more than a degree, you’re looking at a rebuild or an insert system. We’ll show you the footage and give you a straight answer. If it doesn’t need doing, we’ll be the first one to tell you.
Most repairs are scheduled within three to five business days, weather permitting. If the chimney is leaking into the house or the cap has come loose and is a hazard, we’ll find a way to get there sooner. We give you a real arrival window and call if it slips. We’ve been at this since 1999 – we know how to keep a schedule.
Both. Olympia stainless liners hold up well for about 15-20 years on Long Island, but the flex connectors and the joints are the common failure points. We inspect them with a camera, and if the liner’s done, we show you the footage and talk through relining options – including whether a HeatShield or DuraFlex system makes better sense for your setup and budget.
Get a Straight Answer from Top Hat Chimney
If your Olympia Chimney needs repair in Commack, give us a call at (631) 502-3612. You’ll get a live person, an honest price, and a real opinion – not a hard sell. Seniors and veterans always save 10%, any repair over $200 is $40 off, and estimates are free. Wendell’s name is on the work, and he runs into you again on Saturday.
Written by Wendell Pike, Owner, Top Hat Chimney at Top Hat Chimney, serving Commack and nearby areas.