Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Cleaning & Sweep in Commack: What to Know First
Olympia Chimney chimney cleaning and sweep in Commack runs $189 to $329 for a standard open-flue fireplace, depending on creosote buildup, flue height, and whether a Level 1 or Level 2 inspection is needed. We’re an independent Olympia Chimney service provider, not a factory rep, and we complete most sweeps same-visit with pricing confirmed before a single tool comes off the truck. If you own an Olympia fireplace or Olympia flue system and live in Commack, this page covers what actually needs doing, what it should cost, and when we’ll tell you to save your money.
Call (631) 502-3612 for a free estimate. A live person answers, day or night.
How Olympia Chimney Products Fail - and How We Fix Them
Wendell Pike has been inside more Olympia chimneys than he can count, and the failures are rarely mysterious. Here’s what we see in Commack homes, model by model.
- Olympia Ventis flue liners and creosote glaze. Ventis double-wall liners hold heat well, which is good for draft but rough on creosote. Instead of flaking off as soot, the deposits bake into a hard glaze on the inner wall. A standard brush job will not touch it. We use rotary whip heads with carbide-tipped chains to break the glaze without scoring the stainless, then run a camera to verify the liner wall is clean and uncracked.
- Olympia zero-clearance fireplace units and the hidden offset. Many Olympia zero-clearance fireplaces in Commack were installed with an offset in the flue just above the firebox. That bend is the first place soot and creosote collect, and it is the most common spot for a hidden blockage. Our sweep always drops a camera past the offset before and after cleaning, because a brush alone will not show you what is stuck in the bend.
- Olympia chimney caps with undersized mesh. We replace a fair number of Olympia caps where the spark-arrestor mesh is too fine for the amount of fly ash the fireplace produces. The mesh plugs up, draft goes sour, smoke rolls back into the room. The fix is a coarser-mesh cap, often a Copperfield or Famco unit that fits the Olympia flue collar, and the difference in draw is immediate.
- Olympia firebrick and refractory panel joints. On Olympia factory-built fireplaces that are ten years old or more, the refractory panels start to separate at the seams. Hairline cracks there will not cause a chimney fire, but they let heat reach the metal shell behind them. We flag it during the Level 2 inspection, and if the panels are still solid we can seal the seams. If they’re crumbling, replacement is the only honest call.
- Olympia chase-top rust-through. In Commack, the snowy winters and humid summers work on any galvanized chase top. On Olympia prefab units, rust at the chase cover seam is common by year twelve or fifteen. When we see it during a sweep, we’ll show you the camera footage and give you a price to replace the chase top before water gets down into the firebox.
Our Olympia Chimney Chimney Cleaning & Sweep Process
Every Olympia job follows the same sequence, so you know what to expect before we arrive.
- 1
Call and quote. You reach a live person, tell us what you have, and we give you a straight price range based on flue type and last cleaning date. The number on the phone is the number on the invoice.
- 2
Arrival and floor protection. Wendell or one of his crew shows up in uniform, inside the arrival window, and the area around your fireplace gets drop cloths and a vacuum set-up before anything else.
- 3
Inspection and camera run. Before we touch the flue, we run the camera from firebox to cap. You see the video. We tell you what is actually in there.
- 4
Brush and clean. We size the brush to the flue, sweep the full length, and clear the smoke shelf and damper area. First-degree creosote is a brush job. Third-degree is a glaze, and if that is what we find, we’ll tell you and show you before quoting the rotary work.
- 5
Post-clean camera check and verdict. The camera goes back up. You see the result on the spot. If the flue is clean and sound, we say so. If it needs more work, we tell you plainly and hand you a written quote.
- 6
Cleanup and the 90-Day Done Right Promise. We leave your hearth the way we found it, and every job is backed in writing. If it is not right, one call brings us back at no charge.
What Olympia Chimney Chimney Cleaning & Sweep Costs in Commack
For most Olympia fireplaces in Commack, a standard sweep runs $189 to $279 when the creosote is first-degree or light second-degree. A heavy glaze removal with rotary equipment runs $279 to $329. A Level 2 camera inspection, which we recommend if you have never had one or if the home was just purchased, adds $99 to $150. If we find a cracked flue tile, the repair conversation changes, and that quote is always separate and in writing.
What moves the price is mostly the flue condition and the degree of creosote, not the brand. A two-story flue with an offset costs more than a straight one-story run. The honest answer: most Commack sweeps on Olympia systems land in that $189 to $279 range, and we will always tell you if the chimney does not need cleaning yet. Call (631) 502-3612 for a free estimate.
Why Commack Homeowners Call Top Hat Chimney for Olympia Chimney Work
We have worked Commack since 1999, and Wendell has run plenty of jobs through the Burr Farms neighborhood. You will not get a call center, a rotated crew, or a quote that changes at the door. Wendell puts his name on the work, publishes his license number, and backs every Olympia job with the 90-Day Done Right Promise in writing. If it is not right, one call brings him back.
We also service the other brands you might have alongside your Olympia system: DuraFlex liners, HeatShield resurfacing, and Gelco caps. No trip charge inside the county. Free second opinion on any written estimate. Ten percent off always for seniors and veterans. And if the chimney does not need doing, Wendell will be the first one to tell you.
FAQs
No. Olympia warranties cover manufacturing defects, not the routine maintenance every factory-built fireplace requires. Cleaning and inspection done by an independent provider does not void your warranty, and in many cases regular documented maintenance is what keeps a warranty claim viable. Keep your sweep report and camera stills.
Once a year, burn or no burn. Chimneys break in the off-season too, and the spring moisture that gets into a Commack flue will harden light creosote into a glaze by fall. An annual sweep and inspection is cheaper than a crown repair or a liner replacement.
Yes, we keep common Olympia refractory panels, gaskets, and cap components in stock, and we can source factory parts through our suppliers when needed. For many failures, a quality aftermarket part fits better and costs less, and we will show you the difference on the invoice before any work is done.
You need a Level 2 at least once, and you need it now if you recently bought the home, had a chimney fire, changed fuels, or lost a cap. The camera sees the flue wall, the offset, and the chase in a way a brush never will. The footage and a plain-English verdict, every time, no exceptions.
In a Commack climate, skipped years usually mean a glaze buildup in the offset or a rust issue at the chase top. Both are cheaper to fix when caught early. If you are not sure, call us, and we will help you decide if a cleaning is actually due. If it does not need doing, we will be the first ones to tell you.
Written by Wendell Pike, Owner, Top Hat Chimney at Top Hat Chimney, serving Commack and nearby areas.